Check LACP configured correctly

[SussIt]

Hi there,

I was wondering - si there a technote on how to check that LACP is configured correctly for port trunking with 802.3ad?

I have set it up at the switch and the Qnap. Ifconfig follows - is it just a matter of adding up the eth0 and eth1 RX numbers to match up with the bond0 RX number?

Any pointers would be really appreciated


# ifconfig | more
bond0 Link encap:Ethernet HWaddr 00:08:9B:CA:27:56
inet addr:192.168.1.10 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING ALLMULTI MASTER MULTICAST MTU:1500 Metric:1
RX packets:686971149 errors:0 dropped:0 overruns:0 frame:0
TX packets:230705364 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:3128800970 (2.9 GiB) TX bytes:3904943387 (3.6 GiB)

eth0 Link encap:Ethernet HWaddr 00:08:9B:CA:27:56
UP BROADCAST RUNNING SLAVE MULTICAST MTU:1500 Metric:1
RX packets:538441 errors:0 dropped:0 overruns:0 frame:0
TX packets:97486 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:140722491 (134.2 MiB) TX bytes:12684834 (12.0 MiB)
Memory:febe0000-fec00000

eth1 Link encap:Ethernet HWaddr 00:08:9B:CA:27:56
UP BROADCAST RUNNING SLAVE MULTICAST MTU:1500 Metric:1
RX packets:686432708 errors:0 dropped:0 overruns:0 frame:0
TX packets:230607878 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:2988078479 (2.7 GiB) TX bytes:3892258553 (3.6 GiB)
Memory:feae0000-feb00000

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:237313 errors:0 dropped:0 overruns:0 frame:0
TX packets:237313 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:48677377 (46.4 MiB) TX bytes:48677377 (46.4 MiB)