Please help me! I'm going nuts trying to figure out what's wrong with my TS-419P II!
Everything was working fine until I updated the firmware a few days ago, then suddenly the machine refused to boot up. I tried to follow the instructions on http://wiki.qnap.com/wiki/Firmware_Recovery
however the *.iso file would not load up on Oracle VM Virtual Box (I kept receiving "System information disable due to load higher than 1.")
I've followed the reset instruction on the wiki site (bobby pin in the back while holding power) and it's been in the "system booting" mode for the past hour. Please help me! I'm desperate - QNAP support won't answer the phone!
Anything you can do to help is greatly appreciated!