Questions about SNMP, Power, System, Logs, disk, & RAID.
Hello Ive just bought a Qnap TS209 NAS server
I've installed 2 HDD Samsung of 500Gb each.
The latest HDD2 is not detected by NAS in Device Configuration/SATA Disk page(I can't see it).Also the light on the Qnap console concerning this disk is always blinking. What can i do ?
- New here
- Posts: 3
- Joined: Fri Dec 28, 2007 3:33 pm
The repeated post below was deleted.
skouthon wrote:I just happened to find your company web site on the internet and wished to ask you some questions.
First of all :
I finally received my Qnap server yesterday along with 2 Samsung 500Gb HDD.
I managed to install the Qnap finder all along but it only recognise HDD1 while HDD2 disk LED light blinks, I thought it would end blinking at some moment in time
but it doesn't, and my second disk is still not being recognised.
Are you using v1.1.5?
- QNAP Staff
- Posts: 700
- Joined: Mon Aug 27, 2007 1:16 pm
- Location: Taipei
Return to System & Disk Volume Management
Who is online
Users browsing this forum: No registered users and 7 guests