Update Hard Drive firmware in TS-419P+

Questions about SNMP, Power, System, Logs, disk, & RAID.

Update Hard Drive firmware in TS-419P+

Postby mccltd » Sun Jan 02, 2011 7:34 pm

Hi,
I'm running a ts-419p+ with 4 x Seagate 2tb drives in raid 5.
They are model ST32000542AS and running firmware CC34.
I notice there is a CC35 firmware out there and wondered how I go about upgrading the drives firmwares.
Can they be done in the QNAP or do I have to add them to a computer running Windows or Leopard. (have accesss to both)
If I have to pull them and flash them from within a computer can I just pull one out at a time, plug it into a windows machine, flash it and put it back in?
If I do this when I put it back into the NAS will it have to rebuild the array before I pull another one to do the same?

Many thanks,
Dave.
mccltd
Starting out
 
Posts: 47
Joined: Mon Aug 09, 2010 9:29 pm
NAS Model: SS-439 Pro

Re: Update Hard Drive firmware in TS-419P+

Postby schumaku » Mon Jan 03, 2011 7:17 pm

Strongly suggest to simply shotdown the NAS, note or mark the drive slots just in case, update all HDD firmware externally, and then power-up and boot the NAS again. Should not take much more than half of an hour.
User avatar
schumaku
Guru
 
Posts: 29490
Joined: Mon Jan 21, 2008 4:41 pm
Location: Kloten (Zurich), Switzerland -- Skype: schumaku
NAS Model: TS-x79 Pro


Return to System & Disk Volume Management

Who is online

Users browsing this forum: uxsemaj and 15 guests