Hello, this is an English-language-only forum. Please post only in English. Thank you.BennyS wrote: ↑Thu Feb 09, 2023 5:56 pm Il mio QNAP TS-451-4G ad un tratto ha il LED STATUS spento, LED LAN Arancione (cavo lan collegato), LED USB Blu (non c'è nulla collegato sulle USB), LED HDD1 verde (hdd presente), LED HDD2 rosso (hdd presente), LED HDD3 rosso (hdd NON presente), LED HDD4 spento (hdd NON presente), ma NON FUNZIONA NULLA.
On boot, solid red HDD light(no inserted HDD) w/ No status light.
- OneCD
- Guru
- Posts: 12151
- Joined: Sun Aug 21, 2016 10:48 am
- Location: "... there, behind that sofa!"
Re: On boot, solid red HDD light(no inserted HDD) w/ No status light.
-
- Getting the hang of things
- Posts: 75
- Joined: Tue Oct 03, 2017 10:37 pm
Re: On boot, solid red HDD light(no inserted HDD) w/ No status light.
Hi I tried this fix. It does work, but only some weird conditions. If I solder or connect the resistor to the pins, it does not work. Instead if I use a longer cable, no luck
Anyone has an idea? The circuit is working since the exactly same connector is used, just a little longer
Anyone has an idea? The circuit is working since the exactly same connector is used, just a little longer
You do not have the required permissions to view the files attached to this post.
- dolbyman
- Guru
- Posts: 35273
- Joined: Sat Feb 12, 2011 2:11 am
- Location: Vancouver BC , Canada
Re: On boot, solid red HDD light(no inserted HDD) w/ No status light.
Unless it is super sensitive to that extra bit of cable resistance, best to double-check the connection if the non working version, it should really make a difference
-
- Getting the hang of things
- Posts: 75
- Joined: Tue Oct 03, 2017 10:37 pm
Re: On boot, solid red HDD light(no inserted HDD) w/ No status light.
I am VERY puzzled. If I put the resistor in the "non working" mode and I use a tester from the resistor to the lower part of the motherboard, it does test successfully continuity. The connection is there. Same on the other side. But still it does not work. If I use the cable, it does. And it does work also if I use a shorter cable (half the length you see there in the picture). That cable should add a super tiny extra resistance...do you think I should try with a 120ohm or more?
- dolbyman
- Guru
- Posts: 35273
- Joined: Sat Feb 12, 2011 2:11 am
- Location: Vancouver BC , Canada
Re: On boot, solid red HDD light(no inserted HDD) w/ No status light.
I would give it a shot..other people have reported using other resitance values before