I have a qnap ts-639 pro, i changed the min to 100000 (5 zeroes). i ran
Code: Select all
to confirm. however when i run
i get speeds of around 20000 (4 zeroes) and about 1600 min remaining. i tried 80000(4 zeroes),40000 (4 zeroes) before i tried 100000 but it is all the same.
cpu usage is between 25-80%. i would say average around 50%.
am i doing something wrong? maybe this is just the HDs bottle neck? (4x wd 20eads with TLER On and is currently expanding to include 2x hd204ui samsungs (patched)) im on raid 5 and i am just expanding the array
is there anything i should do or should i just leave it?
I guess by the time I figure this out it probably would have finished. 1600 min is about 26 hours. regardless, your help is appreciated.
Thanks for this Don
The % in the webpage is not to be trusted, atleast not for me. Using the "cat /proc/mdstat" command will show different numbers. And those where the accurate one's...
thanks for the tip. they are different.
thanks to the OP too! very helpful!
update: checked this morning and the speed as at 43000! so good stuff! thanks again!