NAS down after Firmware update TS-219P

Discussion on setting up QNAP NAS products.
Post Reply
6grad
First post
Posts: 1
Joined: Sun Aug 18, 2019 1:32 am

NAS down after Firmware update TS-219P

Post by 6grad » Sun Aug 18, 2019 1:43 am

Hi all

Hope someone can give me some advise what I can do.
I installed the latest Firmware as prompted by the System. After the reboot the NAS Stück and is only flashing red/green. The HDD Led are off and only the network LED shows some activity. But the NAS is not online and can’t be found by the Qfinder.

I figured that the Firmware update failed and I tried the recovery as described in the Wiki. But I struggle to reset the NAS. It doesn’t respond to the Reset button. When I plugin the plug it boots up but only the LED is flashing red/green.

I’m out of ideas. Help is much appreciated..

Thanks
Robert

User avatar
spikemixture
Been there, done that
Posts: 761
Joined: Wed Mar 07, 2018 11:04 pm
Location: 3rd World

Re: NAS down after Firmware update TS-219P

Post by spikemixture » Sun Aug 18, 2019 10:02 am

I did the update last night also but on a TVS-1282.

Mine got stuck on checking bios memory ( or similar)
I have a LED screen.

After 15 minutes I just turned it off from the front button.

It came back :o and I now have the latest firmware and all is good
Qnap TS-1277 1700 (48gb RAM) 6x8TB WD White, 2x8TB WD Red - Raid5, 2x M.2 Crucial 1TB (Raid 1 VM),
2x SSD 860 EVO 500gb (Raid1 QTS), 2x SSD 860 EVO 250GB (Cache), 2x M.2 PCIe 970 500gb NVME (Raid1 Plex and Emby server)
GTX 1050 TI
Qnap TVS-1282 i7 (32GB RAM) 8x10TB WD White - Raid 6, 2x M.2 Crucial 500gb (Raid1 VM),
2x SSD EVO 500gb (Raid1 QTS), 2x SSD EVO 250gb (Raid1 Cache), 2x M.2 PCIe Intel 512GB NVME (Raid1-Servers)
Synology -1817+ - 2x10,2x8,2x6 (Ironwolf) 2x6 (WD Red) - SHR
Drobo 5n - 3x2TB WD Green, 2x3TB WD Red - Drobo Raid
Buffalo LinkStation - 2x2TB WD
ProBox 8 Bay USB3 - 8x4TB Seagate - JBOD
All software is updated asap.
I give my opinion from my experience i.e. I have (or had) that piece of equipment/software and used it! :roll:

Post Reply

Return to “Turbo Station Installation & Setup”