Hi,
I was going to delete a LUN but when I deleted it, it stayed in Removing...100% state.
First, I restarted the device, but the status did not change, then I upgraded the firmware, and the status changed to "Error or Blocked" as shown in attachment, and now it cannot be mapped to the target or deleted.
How can I delete it?
Can Not Delete Error or Locked LUN
-
- New here
- Posts: 2
- Joined: Mon Dec 05, 2022 4:10 pm
Can Not Delete Error or Locked LUN
You do not have the required permissions to view the files attached to this post.
-
- Experience counts
- Posts: 2043
- Joined: Thu Mar 03, 2016 1:11 am
Re: Can Not Delete Error or Locked LUN
May you did not wait long enough?
Anyhow, doing reboots/firmware updates when such operations are ongoing is the worst decision you can do!
I am always wondering why, if an unexpected issue occurs, a reboot or update should fix this? A NAS is a bit different than a common PC.
Best option is may be to create a ticket at support and ask for assistance.
Regards
Anyhow, doing reboots/firmware updates when such operations are ongoing is the worst decision you can do!
I am always wondering why, if an unexpected issue occurs, a reboot or update should fix this? A NAS is a bit different than a common PC.
Best option is may be to create a ticket at support and ask for assistance.
Regards
A raid is never a substitute for backup! Never!
Deadbolt - READ 1st post!!!
Deadbolt - information
Deadbolt - find your OP_RETURN!
VPN=VPN? No!
How to clean up your NAS after malware attack
www.raidisnotabackup.com
Deadbolt - READ 1st post!!!
Deadbolt - information
Deadbolt - find your OP_RETURN!
VPN=VPN? No!
How to clean up your NAS after malware attack
www.raidisnotabackup.com
-
- New here
- Posts: 2
- Joined: Mon Dec 05, 2022 4:10 pm
Re: Can Not Delete Error or Locked LUN
I waited for almost 2 hours, but apparently it was not enough.
I registered a ticket, Qnap Technical Team restored the iscsi settings and then I was able to delete the LUN.
Best Regards.
I registered a ticket, Qnap Technical Team restored the iscsi settings and then I was able to delete the LUN.
Best Regards.