Good Morning,
I have a TS-809-Pro setup as an iSCSI target. I copied about 750GB to a 1TB target that I created. I shut the device down overnight. When I powered it back up and connected to the target, the target shows up as empty. If I login to the admin interface and look at the resource monitor, I can see that the disc space is occupied, but I just cannot access it.
Is there a way for me to access that data?
I work with EMC and Equallogic on a daily basis in the course of doing my job, and this hasn't happened yet with those devices...
Any assistance would be greatly appreciated.
Jim
iSCSI Target Shows Up Empty
-
- New here
- Posts: 6
- Joined: Wed Dec 09, 2009 5:44 am
Re: iSCSI Target Shows Up Empty
Hi bd4150,
Try disabling/enabling the iSCSI service on the QNAP and reconnecting to the targets. What I have found in some testing with the current stable firmware is that the iSCSI target service stops responding.
Try disabling/enabling the iSCSI service on the QNAP and reconnecting to the targets. What I have found in some testing with the current stable firmware is that the iSCSI target service stops responding.
-
- New here
- Posts: 2
- Joined: Wed Jan 27, 2010 11:41 pm
Re: iSCSI Target Shows Up Empty
Hi sglaim,
I will give that a shot and will report back here... Interesting...
Thanks
I will give that a shot and will report back here... Interesting...
Thanks