Hello
i have a TS231K and QTS 5.0.1.2145 Build 20220903
So i'm tryng to set a shared folder with guest account access.
But i not see the guest user. I have read this https://www.qnap.com/en/how-to/faq/arti ... re-folders but not result.
I don't see the guest user in folder right.
Thanks
User guest not work
-
- Experience counts
- Posts: 2043
- Joined: Thu Mar 03, 2016 1:11 am
Re: User guest not work
The link shows how to edit the "Advanced Options" in network.
Did you also allow the guest access in share folder properties?
Regards
Did you also allow the guest access in share folder properties?
Regards
You do not have the required permissions to view the files attached to this post.
A raid is never a substitute for backup! Never!
Deadbolt - READ 1st post!!!
Deadbolt - information
Deadbolt - find your OP_RETURN!
VPN=VPN? No!
How to clean up your NAS after malware attack
www.raidisnotabackup.com
Deadbolt - READ 1st post!!!
Deadbolt - information
Deadbolt - find your OP_RETURN!
VPN=VPN? No!
How to clean up your NAS after malware attack
www.raidisnotabackup.com
-
- First post
- Posts: 1
- Joined: Mon Oct 19, 2015 6:27 pm
Re: User guest not work
I had the same issue after upgrading to 5.0.1. Did some clicking around and then it appeared. Notably I clicked through user management menus.
Furthermore, 5.0.1 disabled SMB1, so my TV couldn‘t connect using guest account even if all settings were correct. I had to reenable SMB1 (which is insecure)
Furthermore, 5.0.1 disabled SMB1, so my TV couldn‘t connect using guest account even if all settings were correct. I had to reenable SMB1 (which is insecure)