Surveillance Station stops Motion Event Recrding

Surveillance Station, Surveillance Station Pro, & IP cameras
armalone
Starting out
Posts: 18
Joined: Mon Jan 16, 2017 6:45 pm

Surveillance Station stops Motion Event Recrding

Postby armalone » Fri Sep 22, 2017 7:58 pm

Configuration: TS451; 8GB Memory, 6GB free; Firmware 4.3.3 0299 Build 20170901; Surveillance Station 5.1.1.4.3 (2017/06/01)
Since adding two cameras to my TS451 it works properly and then stops event recording after 12 +/- hours. A restart of the TS251 will allow event recording for a while until the next stoppage.

The Camera overview page of Surveillance Station shows cameras as connected. The Monitor page displays the three cameras correctly I turned on email notification in the Camera configuration and the cameras are detecting motion (they send emails). The TS451 saves nothing once the failure condition occurs and the Surveillance monitor page does not indicate an event.

I thought that it might be a problem with disk storage management. I have the system set to overwrite when greater than 20GB. That does not appear to be an issue since checking the storage space indicates less than 20GB when recording stops.

Other than a QNAP ticket does anyone have any suggestions?

Al

Return to “Surveillance Station”

Who is online

Users browsing this forum: No registered users and 3 guests