QVR Pro : Some Dahua cameras stuck on "Connecting"
Posted: Tue Mar 19, 2019 1:24 am
I purchased a number of Dahua cameras recently - most are model IPC-HDW5231R-ZE.
I did some initial setup with the Dahua ConfigTool as well as by logging into the camera's web interface. All of the cameras have the same username / password as well as identical configuration parmeters. Live video works fine via the web plugin for all three of these cameras.
Adding these cameras to QVR Pro 1.2, all 3 are detected, but the test button produces an error (perhaps this is due to the subtle difference in the available camera model numbers versus the actual model numbers (IPC-HDW5231R-Z vs IPC-HDW5231R-ZE)?). After adding the cameras and looking at the Camera Settings window, one of the cameras connects successfully (Channel 4 in this screenshot), but the two others (Channels 3 and 5) do not, and are perpetually stuck in the "Connecting" state. Since everything is identical about the these 3 cameras, I can't figure out why this would happen. I have gone back several times to each camera's web UI to verify that this is the case. I have also rebooted the cameras, and tried deleting and re-adding them in QVR Pro, but the result seems consistent.
Any ideas?
I did some initial setup with the Dahua ConfigTool as well as by logging into the camera's web interface. All of the cameras have the same username / password as well as identical configuration parmeters. Live video works fine via the web plugin for all three of these cameras.
Adding these cameras to QVR Pro 1.2, all 3 are detected, but the test button produces an error (perhaps this is due to the subtle difference in the available camera model numbers versus the actual model numbers (IPC-HDW5231R-Z vs IPC-HDW5231R-ZE)?). After adding the cameras and looking at the Camera Settings window, one of the cameras connects successfully (Channel 4 in this screenshot), but the two others (Channels 3 and 5) do not, and are perpetually stuck in the "Connecting" state. Since everything is identical about the these 3 cameras, I can't figure out why this would happen. I have gone back several times to each camera's web UI to verify that this is the case. I have also rebooted the cameras, and tried deleting and re-adding them in QVR Pro, but the result seems consistent.
Any ideas?