Howto: Hikvision with PIR & Alarm I/O record on SS

QVR Pro, QVR Pro Client, QVR Center and Surveillance Station
Post Reply
User avatar
DiliMe
Starting out
Posts: 26
Joined: Thu Mar 23, 2017 5:29 pm

Howto: Hikvision with PIR & Alarm I/O record on SS

Post by DiliMe » Tue May 21, 2019 9:33 pm

Hi,
This Howto is about setting a Hikvision Cube (DS-2CD2432F-IW) to record ONLY on events triggered by the PIR sensor (not by the soft motion detection).
I'm writing this tutorial as I have searched from a couple of years for this solution but I haven't found it anywhere on other forums. Hopefully it will help many people to get rid off the soft motion detection which is full of false positives on clouds and light changes as my Cube camera is monitoring an entrance glass door.
First, I hardwired 1 wire strap from Alarm O to Alarm I and by closing the circuit it is recording following this logic: PIR sensor ->> Alarm Out A->1 ->> wire strap -> Alarm In A<-1 ->> Notify Surveillance Center ->> Qnap SS ->> Alarm Input1 = Closed ->> Start Recording Channels 1&2.
Please check the printscreens for the details. It helps following the images from the last one to the first one (this is how it were automagically uploaded and sorted by the forum app).

Cheers!
You do not have the required permissions to view the files attached to this post.
TS-253A

AlastairStevenson
Experience counts
Posts: 2119
Joined: Wed Jan 08, 2014 10:34 pm

Re: Howto: Hikvision with PIR & Alarm I/O record on SS

Post by AlastairStevenson » Wed May 22, 2019 4:44 pm

Hopefully it will help many people to get rid off the soft motion detection which is full of false positives on clouds and light changes as my Cube camera is monitoring an entrance glass door.
Well done, and thanks for sharing for the benefit of others.
That's what community forums are all about.
TS-431+ as primary storage and media server and a bunch of IP cams under Surveillance Station.

Post Reply

Return to “Surveillance Solution”