Page 1 of 1

QVR Pro ONVIF Status Connecting

Posted: Wed Sep 04, 2019 5:23 pm
by QSISteve

Just installing an ONVIF camera onto QVR Pro. When I add the camera the scan picks it up and sets the ports and ONVIF profile etc, but if I press the test button I get the orange exclamation mark which say to check model ip user/pass etc. I've set the user and password but I still get the orange exclamation mark. When I check the status in the camera list it just says connecting and eventually times out to idle.

Any clues. I can connect to the camera using VLC.


Re: QVR Pro ONVIF Status Connecting

Posted: Thu Sep 05, 2019 12:39 am
by QNAPAlanK
Hi Steve

Please contact us to resolve your issue.


(or provide your camera setting value to here.)