Hello.
I have 2 nas devices in a 1 lan. One of this device have 10.0.1.10 ip address. Second one 10.0.1.20 ip address. All devices have scheduled snapshots. I want to setup snapshot replication between devices.
When i make setup the replication on first device do not connect over ssh. All settings are correct. Ip address, port, username and password are correct. i have connected with winscp to device for controlling the settings.. i have connected no problem..
Please look at the attachment. Where i must check on devices?
Snaphot Replication Problem
-
- New here
- Posts: 6
- Joined: Mon Jun 17, 2019 10:07 pm
Snaphot Replication Problem
You do not have the required permissions to view the files attached to this post.
- storageman
- Ask me anything
- Posts: 5507
- Joined: Thu Sep 22, 2011 10:57 pm
Re: Snaphot Replication Problem
Test it to local host on both boxes that 22 works
https://www.qnap.com/en-au/how-to/faq/a ... -properly/
Issue could be these BBCP ports if 22 open
https://www.qnap.com/en-au/how-to/faq/a ... -properly/
Issue could be these BBCP ports if 22 open
-
- New here
- Posts: 6
- Joined: Mon Jun 17, 2019 10:07 pm
Re: Snaphot Replication Problem
Thank you for your respond.
I connected with Winscp with same configuration. But when i try with qnap don't connect. All configurations correct.
I connected with Winscp with same configuration. But when i try with qnap don't connect. All configurations correct.
-
- New here
- Posts: 6
- Joined: Mon Jun 17, 2019 10:07 pm
Re: Snaphot Replication Problem
I solved the problem with reset the settings. Thank you.