QNAP NAS Community Forum

continuation: now it writes: mDNSResponder: mDNSPlatformRawTime went backwards by 141584 ticks; setting correction factor to -104712366

same problem here.

"quick.cgi[1561]: segfault at 9ddd1d64 ip b7708d08 sp bffdc1f0 error 6 in libuLinux_Storage.so.0.0[b76c6000+90000]"

single 250GB disk
hangs with the WebUI showing "20%"

followed these instructions
http://wiki.qnap.com/wiki/Firmware_Reco ... -based_NAS

Hi Danielbaird.

Try this link:
http://wiki.qnap.com/w/index.php?title= ... very_guide
/ptj_11

danielbaird wrote:same problem here.

"quick.cgi[1561]: segfault at 9ddd1d64 ip b7708d08 sp bffdc1f0 error 6 in libuLinux_Storage.so.0.0[b76c6000+90000]"

single 250GB disk
hangs with the WebUI showing "20%"

followed these instructions
http://wiki.qnap.com/wiki/Firmware_Reco ... -based_NAS

I had the same kind of issue for my TS-495Pro+ and found a solution. I posted it here. It may work for you as well, who knows.

Same problem here with a TS-809 Pro.

After this: http://wiki.qnap.com/w/index.php?title= ... very_guide
the recoverty works just like in the documends but i can not update the firmware to something new

I have tried alle firmware versions that are availeble

i tried to upgrade the firmware with Qfind

i tried to upgrade the firmware with dam small linux
http://wiki.qnap.com/w/index.php?title= ... very_guide

i tried to upgrade the firmware with the qnap console
http://wiki.qnap.com/wiki/Manually_Updating_Firmware

I even bought a new DOM 512 Mb to see if it was broken.

Please some one,.... can this be solved?

Same problem here with a TS-809 Pro.

After this: http://wiki.qnap.com/w/index.php?title= ... very_guide
the recoverty works just like in the documends but i can not update the firmware to something new

I have tried alle firmware versions that are availeble

i tried to upgrade the firmware with Qfind

i tried to upgrade the firmware with dam small linux
http://wiki.qnap.com/w/index.php?title= ... very_guide

i tried to upgrade the firmware with the qnap console
http://wiki.qnap.com/wiki/Manually_Updating_Firmware

I even bought a new DOM 512 Mb to see if it was broken.

Please some one,.... can this be solved?

!!!!!!!!!!!!!!!!!!!Solution--UPDATE--!!!!!!!!!!!!!!!!

-- step 1

Firmware recovery
http://wiki.qnap.com/w/index.php?title= ... very_guide

-- step 2
Update the correct firmware with qfinder without any HDD in the Qnap
Firmware can be found here
http://wiki.qnap.com/wiki/NAS_Firmware_ ... _Installed

-- step 3
insert a hard disk (i used a 80Gb deaget bara)
now you can do all 6 steps and after those steps you should be able to loggin to the webinterface and update to the latest version ( i did 4.0.5)

good luck all

The recovery process is to have a bootable NAS again - not to install any current firmware.

Installing the firmware requires a configured system with storage in place.

If you have all that - please follow the process here http://wiki.qnap.com/wiki/Manually_Updating_Firmware - anything else is not verbose enough to see what might go wrong.