Replace Disks After MB Failure

Webslinger22 · Post by **Webslinger22** » Thu Sep 16, 2021 6:56 am

The motherboard in my TVS-672XT failed and I had to send the unit it to have the motherboard replaced. I had to pull all the drives (2 M.2 and 6 HDD) I labeled them for their location in the unit as I removed them. I now have the unit back. What is the best way to replace them and restore the unit to the previous Raid Set up?

dolbyman · Post by **dolbyman** » Thu Sep 16, 2021 7:14 am

make sure the new device is on the latest firmware (disk-less via qfinder) then just stick all disks in the same way you removed them and it should come up the same way as before.

There is a whole thread about the failing x72XT units and how people got their warranty extended, hope you didn't pay for yours
viewtopic.php?f=50&t=153097

Webslinger22 · Post by **Webslinger22** » Sat Sep 18, 2021 5:05 am

Thank You! Thank You! dolbyman. Everything went flawlessly.....Yes, fortunately it was covered under warranty.

QNAP NAS Community Forum

Replace Disks After MB Failure

Replace Disks After MB Failure

Re: Replace Disks After MB Failure

Re: Replace Disks After MB Failure