Threshold Reach but drive has a lot of space

rgatchalian · Post by **rgatchalian** » Mon Jul 31, 2017 2:14 am

A shown on the screenshot all my pools have a lot of space. So I'm not sure what this message is about.

rgatchalian · Post by **rgatchalian** » Mon Jul 31, 2017 2:55 am

I've deleted some files but the pool is full. I still don't understand what the correlation of pool to the actual storage size. and how this link to the Threshold.

Trexx · Post by **Trexx** » Mon Jul 31, 2017 3:36 am

I am assuming you are using thin provisioning as you have over subscribed your Storage Pool. 1) I would run the check filesystem on the dirty file systems. 2) Have you tried running an auto reclaim as outlined in the QTS manual to reclaim space from your deleted files?

rgatchalian · Post by **rgatchalian** » Mon Jul 31, 2017 4:21 am

Hi Trexx,

Yes I am using thin provisioning and yes I am running auto reclaim but I still have the problem. And the storage volumes became read-only.

I found this discussion below and might be related to this issue. If it is then it is related to a bug on the system. I have logged something on the Helpdesk as well. This is the second time happen to me. after upgrades.

viewtopic.php?t=122281

Regards,

storageman · Post by **storageman** » Mon Jul 31, 2017 4:17 pm

Do you have snapshots reserve turned on?

rgatchalian · Post by **rgatchalian** » Tue Aug 01, 2017 3:58 am

HI Storageman,

I don't have reserve turned on. I also have deleted some files and did the space reclamation but pool still full.

Regards,

QNAP NAS Community Forum

Threshold Reach but drive has a lot of space

Threshold Reach but drive has a lot of space

Re: Threshold Reach but drive has a lot of space

Re: Threshold Reach but drive has a lot of space

Re: Threshold Reach but drive has a lot of space

Re: Threshold Reach but drive has a lot of space

Re: Threshold Reach but drive has a lot of space