Re: Automatic rebuld ?
Posted: Fri Aug 31, 2018 9:26 am
If you enable RAID bitmap before pulling the drive, then a rebuild won't be needed when it's reinserted.
That might work. But, as I wrote, new data to the RAID will cause the pulled drive to be out-of-sync.OneCD wrote:If you enable RAID bitmap before pulling the drive, then a rebuild won't be needed when it's reinserted.
QNAP wrote:If the RAID group has a bitmap, only changes that were made after the disk was removed need to be synchronized, greatly speeding up the process.
A sync needs to be done, none-the-less. Shorter the better though.OneCD wrote:QNAP wrote:If the RAID group has a bitmap, only changes that were made after the disk was removed need to be synchronized, greatly speeding up the process.