Hi everybody,
my friend give me a QNAP TS-231P2 that appear broken, but it's new...
The QNAP it's out of garancy.
I checked the power supply and it works good; if i connect a ethernet cable, the port's leds blink.
When I connect the power supply or when I push the power on button, I can't hear any sound from buzzer, and all leds are down.
What can i do ? Can i check if the RAM is good?
I found a guide to replace the firmware but i think that it's not a firmware problem, right ?
I try also to replace the internal battery.
Thank you very much for any help.
TS-231P2 No working led's and no power
-
- New here
- Posts: 3
- Joined: Fri Aug 16, 2019 2:34 am
- dolbyman
- Guru
- Posts: 35249
- Joined: Sat Feb 12, 2011 2:11 am
- Location: Vancouver BC , Canada
Re: TS-231P2 No working led's and no power
if you have a spare compatible RAM stick .. you could try swapping it
try and see if the firmware recovery procedure would work .. you haven't got much to lose here
try and see if the firmware recovery procedure would work .. you haven't got much to lose here
-
- New here
- Posts: 3
- Joined: Fri Aug 16, 2019 2:34 am
Re: TS-231P2 No working led's and no power
I tryed to change RAM without any result. Can I connect with Uart port do make a diagnose ?
- dolbyman
- Guru
- Posts: 35249
- Joined: Sat Feb 12, 2011 2:11 am
- Location: Vancouver BC , Canada
Re: TS-231P2 No working led's and no power
if you find the headers on the board..you could try
no documentation for it available though
no documentation for it available though
-
- New here
- Posts: 3
- Joined: Fri Aug 16, 2019 2:34 am
Re: TS-231P2 No working led's and no power
I think that the problem it's inside a WELTREND WT61P803 chip, maybe it lost it's firmware.... Anyone have this firmware ?
- dolbyman
- Guru
- Posts: 35249
- Joined: Sat Feb 12, 2011 2:11 am
- Location: Vancouver BC , Canada