Hello!
I migrated a RAID1 setup into a new QNAP TS-253D. Everything is fine besides an USB disk that was connected to the old NAS before.
It appears in the new setup (although not attached) as USBDisk1. It is visible in the Shares overview and also in File Station (but cannot be accessed as the device does not exist).
Unfortunately all buttons are greyed out. How can I remove this device from the NAS? Probably using the shell instead of the web interface?
Thanks in advance!
Remove a "ghost" USB device after migration
- Indyone_de
- Starting out
- Posts: 27
- Joined: Wed Apr 09, 2008 6:20 pm
Remove a "ghost" USB device after migration
You do not have the required permissions to view the files attached to this post.
- dolbyman
- Guru
- Posts: 35276
- Joined: Sat Feb 12, 2011 2:11 am
- Location: Vancouver BC , Canada
Re: Remove a "ghost" USB device after migration
Always remember to switch your UI from German to English before posting in an English forum.
What was the migrated unit model? Hope not CAT1 resulting in a legacy volume
What was the migrated unit model? Hope not CAT1 resulting in a legacy volume
- Indyone_de
- Starting out
- Posts: 27
- Joined: Wed Apr 09, 2008 6:20 pm
Re: Remove a "ghost" USB device after migration
The old unit was a TS-259 Pro+.
- OneCD
- Guru
- Posts: 12163
- Joined: Sun Aug 21, 2016 10:48 am
- Location: "... there, behind that sofa!"
Re: Remove a "ghost" USB device after migration
Yep, that's a CAT1 unit.
- dolbyman
- Guru
- Posts: 35276
- Joined: Sat Feb 12, 2011 2:11 am
- Location: Vancouver BC , Canada
Re: Remove a "ghost" USB device after migration
so best thing to kill the NAS and start from fresh with a full static volume or storage pool
that (hopefully) should also take care of this device
that (hopefully) should also take care of this device
- Indyone_de
- Starting out
- Posts: 27
- Joined: Wed Apr 09, 2008 6:20 pm
Re: Remove a "ghost" USB device after migration
Ok, thanks.