UNMOUNTED VOLUMES After Disk Failure

[buztan99]

I have a TS-869 Pro using a RAID 6 config with 5 Western Digital Black 3TB Drives and 1 Spare. Drive 3 failed a couple of weeks ago. When I logged into the Admin website, Disk 3 no longer appeared as part of the RAID, and Disk 8 is no longer a spare and is now part of the RAID. Additionally, my three volumes all show 'X UNMOUNTED'. I inserted a new 4TB drive and it was added to the RAID. I attempted to perform the 'Recover' command but it is grey'd out. As of now, all drives are Green-Good and my three volumes are UNMOUNTED.

Any suggestions on how to recover the volumes is appreciated.

[dolbyman]

Make sure you use NAS drives, WD black are NOT NAS drives.

Please login to the NAS via SSH and do

Code: Select all

md_checker

and post back the results

[buztan99]

I am replacing the bad WD Black 3TB with WD Red 4TB and will replace the others asap. I'll check via SSH later today and post the results. Thank you.

[OneCD]

I am replacing the bad WD Black 3TB with WD Red 4TB and will replace the others asap.

Which model WD Red are you installing?

[buztan99]

I'm installing WD4003FFBX drive..

When I log into QNAP using SSH or PUTTY, it accepts my admin creds then pauses for appx 10 seconds then returns the following:
client_loop: send disconnect: Connection reset

Any suggestions?