Hello. I have a TS-410 running firmware 4.2.0
I can configure the Symform app just fine and believe it is syncing. Once I ran the initial configuration though I can no longer access the app on the NAS. I'd like to make changes / add folders but it never opens. When I click open it just takes me to x.x.x.x:59234 and sits there.
Any thoughts?
Symform can't access 'Remote Device Manager' after config
-
- New here
- Posts: 4
- Joined: Fri Apr 13, 2012 4:55 am
-
- Starting out
- Posts: 42
- Joined: Wed Oct 07, 2009 6:25 pm
- Location: Copenhagen, Denmark
Re: Symform can't access 'Remote Device Manager' after config
Has happened to me too.
If I log into http://control.symform.com I can see that my Qnap gave Symform a heartbeat 9 minuttes ago, but the folders I've selected haven't sync'ed for about 24 hours.
Seems like there's an issue with the Symform software running on the 4.2.1, which I'm running.
I've opened a ticket with symform... maybe they'll look into it....
/Kasper
If I log into http://control.symform.com I can see that my Qnap gave Symform a heartbeat 9 minuttes ago, but the folders I've selected haven't sync'ed for about 24 hours.
Seems like there's an issue with the Symform software running on the 4.2.1, which I'm running.
I've opened a ticket with symform... maybe they'll look into it....
/Kasper
-
- Starting out
- Posts: 42
- Joined: Wed Oct 07, 2009 6:25 pm
- Location: Copenhagen, Denmark
Re: Symform can't access 'Remote Device Manager' after config
Apparently this problem solved it self for me after a couple of hours... Hope yours do to.
/Kasper
/Kasper