Upnp auto config not working after changing switch

Post your questions about myQNAPcloud service here.
Post Reply
Alanwood04
New here
Posts: 2
Joined: Sat Jan 03, 2015 9:54 pm

Upnp auto config not working after changing switch

Post by Alanwood04 »

So my nas was connected to a unmanaged switch which in turn was connected to my ee router. Setup went fine and it all worked as it should.
I recently changed the switch to a HP Procurve 1810g-24 which was set to factory defaults so in theory should work but in practice it stopped the mycloud from working and the nas could no longer see the upnp on the router, if i go into the router and manually configure ports it will work but why should the switch stop this feature from working. The switch has no CLI just a web based gui.

Any thoughts or ideas would be appreciated before i buy another unmanaged switch.
User avatar
storageman
Ask me anything
Posts: 5507
Joined: Thu Sep 22, 2011 10:57 pm

Re: Upnp auto config not working after changing switch

Post by storageman »

Unmanaged
SMART/Web-based
Managed

So maybe the Procure is blocking ports?
Check it.
Post Reply

Return to “myQNAPcloud service”