Page 1 of 1

Configuring Qfile connection after having established QVPN connection

Posted: Sun Apr 07, 2019 2:12 am
by PIRATA!
I have configured QVPN on both TS-251+ and my Android smartphone...but after having established the tunnel, if I have to access to my files stored in my nas I hit on Apps in the QVPN Android app, and then again on Qfile....and the Qfile installed on my smartphone starts up asking me to connect to my NAS!!

I a bit confused as I though that QVPN app established already the tunnel + the connection with my nas directly so to use directly apps remotely...

Do I have to launch a connection to the nas using Qfile app so to access to files??
Do I have to create a brand new connection to my nas using maybe some particular IP address?? I see under available connection methods a list of Hosts: By Host/IP, By LAN IP, By myQNAPcloud, By CloudLink, By WAN IP....

Please help me understand this practical new world for me.

Thank you.

Re: Configuring Qfile connection after having established QVPN connection

Posted: Sat Apr 20, 2019 4:24 am
by PIRATA!
Any one??

Thank you.

Re: Configuring Qfile connection after having established QVPN connection

Posted: Sat Apr 20, 2019 7:01 am
by dolbyman
when the vpn is established, all app communications should be done by lan ip .. nothing else

Re: Configuring Qfile connection after having established QVPN connection

Posted: Sat Apr 20, 2019 7:35 am
by PIRATA!
dolbyman wrote: Sat Apr 20, 2019 7:01 am when the vpn is established, all app communications should be done by lan ip .. nothing else
Ok, By LAN IP...but I have several LAP IP!!! Should I choose the IP that I have set inside the QVPN page??

Thank you.

Re: Configuring Qfile connection after having established QVPN connection

Posted: Sat Apr 20, 2019 9:17 am
by dolbyman
lan ip of your nas

tunnel subnets should be traversed transparently