Web server stopped working

[Lumikor]

QNAP TS-451+, 4 GB,

After upgrading to the latest firmware (4.3.6.0923) the web server stopped working, whenever I'm trying to access it, I'm getting page not found error. I've checked the ports to make sure, I've checked the IP address to make sure, but whenever I'm trying to access it, directly in my internet network (192.168.0.10x:30) or the using the domain name, I get the same crappy error.

Anyone with tips? Used to work fine and I ran my website without any issues for months.

[Blackbar7]

QNAP TS-451+, 4 GB,

After upgrading to the latest firmware (4.3.6.0923) the web server stopped working, whenever I'm trying to access it, I'm getting page not found error. I've checked the ports to make sure, I've checked the IP address to make sure, but whenever I'm trying to access it, directly in my internet network (192.168.0.10x:30) or the using the domain name, I get the same crappy error.

Anyone with tips? Used to work fine and I ran my website without any issues for months.

the webserver (httpd) is listening on port 30?

[Lumikor]

yes

[dolbyman]

there is no letters ipv4 ..so if you ip ends in 10x then it will not work

a domain name would mean you either have dns/host entries locally or the webserver is also accesible from the internet (portforward) ..any info on that?

[Lumikor]

there is no letters ipv4 ..so if you ip ends in 10x then it will not work

a domain name would mean you either have dns/host entries locally or the webserver is also accesible from the internet (portforward) ..any info on that?

The x is just to hide the full ip, it's not really there....

[dolbyman]

hiding a private range IP is not that useful , unroutable from the outside and definitely not unique .. just makes troubleshooting harder

does downgrading the firmware have any effect on the webserver ?