[ OsCAM ] [ 1.20.11717 ] Card Server

[politby]

Greetings

I just got a TS-1635 and installed the x41 version which runs great - until I try to configure it with my ** pcsc reader. It just says it can't initialize the reader and then dies.

No support for pcsc? If so which reader should I be using?

No one?

[Ted377]

No, sorry

[Ted377]

thanks for addressing this issue, how can i disable it to test?

edit:
Hey @Qnap_Stephane i know can connect... because iam a noob and press buttons without knowing what they will do i went to network settings of my nas and enabled ipv6... and know it connects to tvh... it was so easy to fix this.

Because i didn´t know how to disable ipv6 on oscam and i didn´t have network i went to search that option and is easy, just enable ipv6 on network and virtual switches settings.

your qpkg works fine.

@Ted377 try to do that if it´s possible on your NAS

I've activated IPv6 on the NAS and thus the connection to TVHeadend works again. But that can not be the purpose of the cause.

[Norin]

well it was just an easy fix for me But i see your point.

[Ted377]

Greetings

I just got a TS-1635 and installed the x41 version which runs great - until I try to configure it with my ** pcsc reader. It just says it can't initialize the reader and then dies.

No support for pcsc? If so which reader should I be using?

Try it with this cardreader. It works wonderfully.
EASYMOUSE 2 USB PREMIUM

[lieschen1983]

I have the problem that the "CCCAM" of the server is no longer available

to edit

After 5 minutes the server is reachable with the message
cccam: Binding request failed (address family is not supported by the protocol), wait another 119 seconds

[lieschen1983]

I also think that it is support from ipv6

[lieschen1983]

I once created a new OScam 11420
without IPv6
with USB support (Smartreader)
http://filehorst.de/d/ccJsplDs

[Ted377]

I once created a new OScam 11420
without IPv6
with USB support (Smartreader)
http://filehorst.de/d/ccJsplDs

Which devices or architectures are supported?

[lieschen1983]

I once created a new OScam 11420
without IPv6
with USB support (Smartreader)
http://filehorst.de/d/ccJsplDs

Which devices or architectures are supported?

Intel Atom

[Ted377]

I once created a new OScam 11420
without IPv6
with USB support (Smartreader)
http://filehorst.de/d/ccJsplDs

Which devices or architectures are supported?

Intel Atom

Too bad, then I have to wait for the ARM version. I hope that QNAP_Stephane can do something else.

[QNAP_Stephane]

updated (ipv6 disable)

[Ted377]

updated (ipv6 disable)

Great Work
Thank you !!

[QNAP_Stephane]

you are welcome

[Ted377]

Hello QNAP_Stephane, can you bring an update to Rev. 11432 ?
Many Thanks