[ Par2 ] [ 0.8.1.0 ] a PAR 2.0 compatible file verification and repair tool.

[OneCD]

my workaround with Musl Toolchain worked

and was built statically (arm-x19 availalble on Qnapclub)

Nice job, thank you!

[OneCD]

Hi Stephane, just noticed the current QPKG version has $QTS_MAX_VERSION set to "5.0.0".

It may not be too long until a QTS version later than this is released. When this happens, I suspect these older QPKGs will break. Can you please release updated versions of these with a higher (or removed) $QTS_MAX_VERSION?

Thank you.

[OneCD]

Hi Stephane, just noticed the current QPKG version has $QTS_MAX_VERSION set to "5.0.0".

It may not be too long until a QTS version later than this is released. When this happens, I suspect these older QPKGs will break. Can you please release updated versions of these with a higher (or removed) $QTS_MAX_VERSION?

Hi Stephane, any progress with this? The beta for QTS 5.0.1 is out and the current Par2 QPKG doesn't run without some hacking.

[QNAP_Stephane]

it is released

[OneCD]

Thank you.

[OneCD]

Hi Stephane, it looks like there's been some development of Par2 by a new maintainer: https://github.com/animetosho/par2cmdline-turbo

Current version is 1.1.0

Would you consider switching/upgrading these QPKGs, or creating a new Par2cmdline-turbo QPKG?

Thank you.

[OneCD]

Hi Stephane, it looks like there's been some development of Par2 by a new maintainer: https://github.com/animetosho/par2cmdline-turbo

Current version is 1.1.0

Would you consider switching/upgrading these QPKGs, or creating a new Par2cmdline-turbo QPKG?

Thank you.

Thank you Stephane, I've seen the new version on the MyQNAP store.

[QNAP_Stephane]

you are <elcome