How to enable Jumbo Frames MTU 9000 on TS 453A QTS 4.3.3

[viktormadarasz]

Hi

How can i enable either from the GUI or Console Jumbo Frames with MTU 9000 value for my TS 453A?

Im on QTS 4.3.3 and I can not seem to find the option at all

Thanks

Viktor

[P3R]

Read the fine manual.

Also remember that you need to enable jumbo frames on the networking equipment (routers/switches) as well.

[viktormadarasz]

Read the fine manual.

Also remember that you need to enable jumbo frames on the networking equipment (routers/switches) as well.

Hi P3R

thanks

I did find however what the manual does not seem to mention :

- Once the interface is part of a Virtual Switch you can not alter its MTU or VLAN settings

so i needed to remove it from the VS and then modify then place it back

Thanks for helping

Regards

Viktor

[P3R]

- Once the interface is part of a Virtual Switch you can not alter its MTU or VLAN settings...

Okay, I haven't tried that...yet.

...so i needed to remove it from the VS and then modify then place it back

Great information to have here in the forum. It will probably help others (including me) in the future. Thank you for contributing to the community!

[Johnno72]

- Once the interface is part of a Virtual Switch you can not alter its MTU or VLAN settings

so i needed to remove it from the VS and then modify then place it back

Viktor

I confirm this information as Viktor posted. When linking multiple NIC's on the NAS they need to be in individual / normal mode, once changes have been done, they can once again be linked.

The manual's are a bit thin with this information.