When I first try setup, to "Smart Installation" was found on the webgui, so I decided to downgrade to 5.0.0 build with the setup now show the "Smart Installation" button, after pressing the button, show "No disks".
After inspect via ssh, all 12 bays do green led when disk is on and disk show in /dev/sd*, but on first setup always show "No disks"
At this point I make a serial cable to reach debug on boot firmware, and I found the disks are recognised as removable drives and no internal drives.
on boot sequence I see this on debug console line:
Code: Select all
ata4: SATA link up 6.0 Gbps (SStatus 133 SControl 330)
ata4.00: ATA-11: ST4000NE001-2MA101, EN01, max UDMA/133
ata4.00: 7814037168 sectors, multi 16: LBA48 NCQ (depth 32), AA
scsi 3:0:0:0: Direct-Access Seagate ST4000NE001-2MA1 EN01 PQ: 0 ANSI: 5
ata4.00: set queue depth = 32
sd 3:0:0:0: [sda] 7814037168 512-byte logical blocks: (4.00 TB/3.64 TiB)
sd 3:0:0:0: [sda] Attached SCSI removable disk
Code: Select all
[~] # /sbin/storage_util --sys_startup
Detect disk(8, 16)...
ignore non-root enclosure disk(8, 16).
Detect disk(8, 0)...
ignore non-root enclosure disk(8, 0).
dev_count = 0
Detect disk(8, 16)...
ignore non-root enclosure disk(8, 16).
Detect disk(8, 0)...
ignore non-root enclosure disk(8, 0).
[garbage url removed]
Is there any file to check like enclosure configuration or external drives vs internal drives?
Thanks.