Hi,
3 times now before applying the latest firmware, I restart the NAS as per recommendation.
Can't connect after re-start
Open Qfinder and find that it reverted to another IP address, and Qfinder states that the device is un-configured, do I want to run the configuration Wizard.
The only way to fix it is to Power Off at the Power button (Not Great practice) then it comes back to normal configured state.
This happens before the firmware upgrade restart and also after the firmware upgrade re-start, both times I need to be on premises to power down and power up.
While powered down, I pull out the disks and re-seat them, next time still the same.
Any thoughts?
Details below:
TS-219P+
Firmware - 4.3.3.0361 (2017/11/01)
2 Disks Installed
Disk 1
Samsung HD204UI 1AQ1
Firmware - 1AQ10001
2 TB
Disk 2
Samsung HD204UI 1AQ1
Firmware - 1AQ10001
2 TB
TS-219P+ Reverts back to Un-Configured State when Restarted
-
- Starting out
- Posts: 14
- Joined: Thu Mar 27, 2008 5:01 pm
- dolbyman
- Guru
- Posts: 35253
- Joined: Sat Feb 12, 2011 2:11 am
- Location: Vancouver BC , Canada
Re: TS-219P+ Reverts back to Un-Configured State when Restarted
did it start out of the blue..or as a result of a firnware update?
-
- Starting out
- Posts: 14
- Joined: Thu Mar 27, 2008 5:01 pm
Re: TS-219P+ Reverts back to Un-Configured State when Restarted
Probably the last 3 firmware updates, I think it may have started from one of the past firmware updates, not sure.
When it started I just thought it was just a glitch, but now it is every time ?
When it started I just thought it was just a glitch, but now it is every time ?
- dolbyman
- Guru
- Posts: 35253
- Joined: Sat Feb 12, 2011 2:11 am
- Location: Vancouver BC , Canada
Re: TS-219P+ Reverts back to Un-Configured State when Restarted
contact qnap..if it is a bug..they need to see it