TS-253A and Seagate IronWolf - increasing Load_Cycle_Count
-
- First post
- Posts: 1
- Joined: Sat Nov 04, 2017 10:16 am
Re: TS-253A and Seagate IronWolf - increasing Load_Cycle_Count
@bart_snp I have the 4TB Seagate IronWolf drive and my LCC is at 60,000 in around 100 days. After adding the hdparm -B 255 /dev/sda/ to autorun the count has stopped going up. I opened a ticket w/ Seagate who claims it is working as expected. I also have a WD RED 4TB in the same TS-251A that doesn't have the same issue. I have also opened a ticket with QNAP who is looking into the issue. I suggest you do the same!
-
- New here
- Posts: 2
- Joined: Mon Jan 01, 2018 7:12 pm
Re: TS-253A and Seagate IronWolf - increasing Load_Cycle_Count
I have the same issue with my 10TB IronWolf PRO. I disabled the EPCfeature - it seams that the LCC is no longer increasing.
Do I have to disable EPCfeature again after reboot?
Do I have to disable EPCfeature again after reboot?
Code: Select all
SeaChest_Powerchoice_103_193_64 --EPCfeature disable –d /dev/sg#
-
- Starting out
- Posts: 21
- Joined: Tue Oct 30, 2018 12:13 am
Re: TS-253A and Seagate IronWolf - increasing Load_Cycle_Count
Hi Seb666!seb666 wrote:Hi Ron,
the hdparm command ("-B 255") did the trick for me.
Before, the drive parked its heads immediately when it became idle.
This gave me a load cycle count increase by about 400/day.
I was reading about other Seagate drives having "clicking issues" with Synology NASes before, but after a short glance at the topic you linked, this doesn't seem to be the same issue.
For me, the drive parked the head only when it became idle and "unparked" it when it was active.
No constant clicking noises when it stayed idle.
Anyway, after issuing the hdparm command to disable the drive's APM, the load cycle count has not increased at all:
SebastianCode: Select all
[~] # hdparm -B 255 /dev/sda /dev/sda: setting Advanced Power Management level to disabled [~] # hdparm -B 255 /dev/sdc /dev/sdc: setting Advanced Power Management level to disabled
Could you please give me an advice, how can I edit & put this code into my autorun.sh ?
Thanks in advance,
Bob
-
- Starting out
- Posts: 21
- Joined: Tue Oct 30, 2018 12:13 am
Re: TS-253A and Seagate IronWolf - increasing Load_Cycle_Count
Ok.. I've solved the problem, but the QTS GUI doesn't show the edited autorun.sh
Any idea?
Any idea?