Hello!
I have a question on connection ESP8266 to QIoT.
What I have:
1) QNAP D4 PRO with the latest 4.3.4.0695 and QIoT 1.1.298
2) I have a relay based ob esp8266-12 and try to connect it over MQTT
I created sketch for ESP8266 and according to log - it coonected to WiFi and connected to MQTT broker.
The problem is that I can't deploy Thing on QIoT - because there is no connection over SSH to it. What I need to do to fix it?
ESP8266 + QIoT
-
- New here
- Posts: 8
- Joined: Wed Nov 15, 2017 12:12 pm
Re: ESP8266 + QIoT
Hi wlad_wm
You can reference this tutorial :
https://www.qnap.com/en/how-to/tutorial ... suite-lite
ESP8266 didn't support SSH, so it can't use deploy function in QIoT. Must be manual to deploy your code to ESP8266.
Thank you.
You can reference this tutorial :
https://www.qnap.com/en/how-to/tutorial ... suite-lite
ESP8266 didn't support SSH, so it can't use deploy function in QIoT. Must be manual to deploy your code to ESP8266.
Thank you.
-
- First post
- Posts: 1
- Joined: Mon Nov 12, 2018 10:26 am
Re: ESP8266 + QIoT
Hello,
I also tried to connect a ESP8266 to the MQTT Broker.
I used the button and led example from the tutorial.
The button state can be displayed on the dashboard without any problem, but the ESP8266 is not switching on the led.
On the serial monitor of the Arduino ide I can see the publish message for the broker, but no receive message.
I already tested the led with a very simple sketch just to make sure there is no hardware issue or a wrong connection.
What could be the problem?
I also tried to connect a ESP8266 to the MQTT Broker.
I used the button and led example from the tutorial.
The button state can be displayed on the dashboard without any problem, but the ESP8266 is not switching on the led.
On the serial monitor of the Arduino ide I can see the publish message for the broker, but no receive message.
I already tested the led with a very simple sketch just to make sure there is no hardware issue or a wrong connection.
What could be the problem?