How to configure resource monitor (Network IF)? Some IF won't show

[clueless1]

The resource monitor (Adapter section) of a TS-859 running 4.3.5.0713 only shows 4 of 6 physical NIC's. 1+2 are internal, 4+5 the first separate NIC (Intel 1gb dual port). 1+2 are grouped and 4+5, too. The 4 single ports and the 2 groups are displayed by the resource monitor.
But the second separate NIC (Intel 10gb dual port) doesn't. Traffic flows up to 600mb/s and I can see that under control panel/system resources. But this displays the overall network traffic and not separated by the NIC's.
Any idea how to tell this monitor to display every NIC?

[clueless1]

Probably my description is somehow unclear....here are two screenshots:

rmon1.jpg

rmon2.jpg

[storageman]

Have you tried using Service Binding to limit traffic to the 10GbE ports?

[clueless1]

Have you tried using Service Binding to limit traffic to the 10GbE ports?

Not yet....but no change after activating service binding. Even no change after installing 4.3.5-0722 firmware and a reboot. Strange....

[Trexx]

You could try the following commands to reset NW stack (from another thread).

Code: Select all

/mnt/ext/opt/netmgr/netmgr.sh reset_all_settings_to_default
/etc/init.d/network.sh reset_network_config_to_default
/etc/init.d/network.sh clean-restart 

I would disable any 2nd port on your NW teams to prevent issues connecting.

I would disable Container Station & Virtual Station prior to running these and you likely would have to reinstall Virtual Station & Container Station after this.

[clueless1]

You could try the following commands to reset NW stack (from another thread)......

Thanks for helping out. Actually I'm out of time and will try at the end of October and come back with the result.