Hi,
I factory reseted my TS-853A nas following these instructions https://www.qnap.com/en/how-to/faq/arti ... -settings/
I have three LUNs created, which were previously mapped under two targets.
I have now recreated the targets, but cannot find anywhere where to map the luns.
If I go to Control Panel -> Storage & Snapshots -> Storage I can see my three Block-based Thick LUNs there.
Any advice?
How to map existing iSCSI LUNs to iscsi target?
-
- Starting out
- Posts: 36
- Joined: Tue Aug 20, 2013 1:28 pm
How to map existing iSCSI LUNs to iscsi target?
TS-853A 4GB 5x Seagate IronWolf 6TB + 2x SSD 860 QVO 1TB
TS-1673U-RP 24GB 12x Seagate IronWolf Pro 12TB + 2x SSD 860 EVO M.2 2TB
TS-1673U-RP 24GB 12x Seagate IronWolf Pro 12TB + 2x SSD 860 EVO M.2 2TB
- storageman
- Ask me anything
- Posts: 5506
- Joined: Thu Sep 22, 2011 10:57 pm
Re: How to map existing iSCSI LUNs to iscsi target?
Really???hyvokar wrote: ↑Mon Apr 22, 2019 11:29 pm Hi,
I factory reseted my TS-853A nas following these instructions https://www.qnap.com/en/how-to/faq/arti ... -settings/
I have three LUNs created, which were previously mapped under two targets.
I have now recreated the targets, but cannot find anywhere where to map the luns.
If I go to Control Panel -> Storage & Snapshots -> Storage I can see my three Block-based Thick LUNs there.
Any advice?
Found it yet?
-
- New here
- Posts: 4
- Joined: Thu Jul 25, 2019 6:26 pm
Re: How to map existing iSCSI LUNs to iscsi target?
on my 1273 I click storage & snapshots, I click iscsi storage. At the top of the list in the middle I see my targets (and can drill down into the target to access any LUNs already mapped). unmapped LUNS appear at the bottom. I click an unmapped lun and "map" it using the "action" drop down in the top right. This lets me map to a target.
likewise to unmap a LUN, I click a LUN under a target, use "disable" under the "action" drop down. Then click "unmap" under the "action", thus then lists the LUN as unmapped.
likewise to unmap a LUN, I click a LUN under a target, use "disable" under the "action" drop down. Then click "unmap" under the "action", thus then lists the LUN as unmapped.
-
- Starting out
- Posts: 36
- Joined: Tue Aug 20, 2013 1:28 pm
Re: How to map existing iSCSI LUNs to iscsi target?
Never found those. Helpdesk luckily was able to make them visible again.
TS-853A 4GB 5x Seagate IronWolf 6TB + 2x SSD 860 QVO 1TB
TS-1673U-RP 24GB 12x Seagate IronWolf Pro 12TB + 2x SSD 860 EVO M.2 2TB
TS-1673U-RP 24GB 12x Seagate IronWolf Pro 12TB + 2x SSD 860 EVO M.2 2TB