How to map existing iSCSI LUNs to iscsi target?

iSCSI related applications
Post Reply
hyvokar
Starting out
Posts: 24
Joined: Tue Aug 20, 2013 1:28 pm

How to map existing iSCSI LUNs to iscsi target?

Post by hyvokar » Mon Apr 22, 2019 11:29 pm

Hi,

I factory reseted my TS-853A nas following these instructions https://www.qnap.com/en/how-to/faq/arti ... -settings/

I have three LUNs created, which were previously mapped under two targets.

I have now recreated the targets, but cannot find anywhere where to map the luns.

If I go to Control Panel -> Storage & Snapshots -> Storage I can see my three Block-based Thick LUNs there.

Any advice?
TS-853A 4GB 5x Seagate IronWolf 6TB + 2x SSD 860 QVO 1TB
TS-1673U-RP 24GB 12x Seagate IronWolf Pro 12TB + 2x SSD 860 EVO M.2 2TB

User avatar
storageman
Experience counts
Posts: 4943
Joined: Thu Sep 22, 2011 10:57 pm

Re: How to map existing iSCSI LUNs to iscsi target?

Post by storageman » Mon Apr 29, 2019 6:00 pm

hyvokar wrote:
Mon Apr 22, 2019 11:29 pm
Hi,

I factory reseted my TS-853A nas following these instructions https://www.qnap.com/en/how-to/faq/arti ... -settings/

I have three LUNs created, which were previously mapped under two targets.

I have now recreated the targets, but cannot find anywhere where to map the luns.

If I go to Control Panel -> Storage & Snapshots -> Storage I can see my three Block-based Thick LUNs there.

Any advice?
Really???
Found it yet?

kktwenty
New here
Posts: 3
Joined: Thu Jul 25, 2019 6:26 pm

Re: How to map existing iSCSI LUNs to iscsi target?

Post by kktwenty » Thu Jul 25, 2019 6:52 pm

on my 1273 I click storage & snapshots, I click iscsi storage. At the top of the list in the middle I see my targets (and can drill down into the target to access any LUNs already mapped). unmapped LUNS appear at the bottom. I click an unmapped lun and "map" it using the "action" drop down in the top right. This lets me map to a target.

likewise to unmap a LUN, I click a LUN under a target, use "disable" under the "action" drop down. Then click "unmap" under the "action", thus then lists the LUN as unmapped.

hyvokar
Starting out
Posts: 24
Joined: Tue Aug 20, 2013 1:28 pm

Re: How to map existing iSCSI LUNs to iscsi target?

Post by hyvokar » Wed Sep 25, 2019 1:01 am

storageman wrote:
Mon Apr 29, 2019 6:00 pm
Really???
Found it yet?
Never found those. Helpdesk luckily was able to make them visible again.
TS-853A 4GB 5x Seagate IronWolf 6TB + 2x SSD 860 QVO 1TB
TS-1673U-RP 24GB 12x Seagate IronWolf Pro 12TB + 2x SSD 860 EVO M.2 2TB

Post Reply

Return to “iSCSI – Target & Virtual Disk”