Motion Detection on QVR Pro for MOBOTIX T24

[haumichblau]

Hello,
I am using QVR Pro. I managed to configure the recording of the T24. But the motion detection does not work.

Under Survaillance Station it worked with FTP-Upload. But I think in QVR Pro there is an other mechanism.

Do you have any tips how to configure Motion Detection?

My NAS has the actual firmware 4.4.1.1086 and THE MOBOTIX T24 has the version MX-V4.7.2.18.

Best regards,
Christian

[AlastairStevenson]

Does the Mobotix device have in-built motion detection, and have you configured it?
If not - you will need to use QVRPro motion detection instead of camera motion detection.

[haumichblau]

Yes Motion Detection is active. I also get the red frame in the Live View when a motion has been detected.

But which event should I raise when the motion was detected?

Now I have "Visual Alarm: Red Frame". But what should I add that QVR Pro is informed?

Best regards,
Christian

[AlastairStevenson]

Presumably you want to configure a recording event in response to the motion notification.

[haumichblau]

Yes. You are right.

Best regards,
Christian

[haumichblau]

Hello,

Does anyone use QVR Pro with a MOBOTIX IP-Camera with motion detection?


Best regards,
Christian