Is there any way to tweak the system to have the recording start ex. 5 sec before / after a motion detection?
Today I'll have to choose between 30 and 300 seconds and I can't see the point recording 30 seconds before a motion detection....
I changed /etc/config/nvrd.xml with these settings:
else if(document.form1.PreRecording.value < 5 || document.form1.PreRecording.value > 300).
else if(document.form1.PostRecording.value < 5 || document.form1.PostRecording.value > 300).
I can now Apply settings with 5 seconds under Advanced Settingsd without any error message.
But the camera still proceed to make huge files with many seconds prior/after a motion detection.
Any advice how to change this?
QVR Pro, QVR Pro Client, QVR Center and Surveillance Station
1 post • Page 1 of 1